Dana 60 Ring And Pinion Installation Instructions

These are the last bolts you want working their way loose in your diff.

Dana 60 ring and pinion installation instructions.

We have personally experienced good results using the techniques in these instructions while setting up over forty thousand differentials. When setting the pinion position many of the service manuals required a final pinion position check by using gauges that verified the dimension from the center line of the differential carrier center line of ring gear to the face of the pinion button. The job being done. This is adjusted by adding or subtracting shims to the inner pinion bearing.

Dana 60 arb and ring and pinion installation. 6 with the pinion gear installed position ring. Install ring gear bolts with a six point socket and torque. If you re changing the ring and pinion or the pinion bearings remove the pinion nut with an air gun while holding the yoke or use a long breaker bar and brace the yoke bolt it to a long board so that it can t move.

Dana 60 110 85 ford 8 70 50 60 ford 8 8 70 70 85 ford super 8 8 irs 97 102 76 89 ford 9 70 120 80 90 gm 8 4 65 60 gm 8 6 60 65 gm 12 bolt 8 875 45 60 65 fastener choice affects the amount of torque that can be applied. During the ring pinion installation there are four pr imary adjustments that will need to be made. Knock the pinion gear out to the rear with a brass punch taking care not to damage the threads. 5 once the pinion depth is achieved install a new crush collar preload shim pack for dana s and seal.

Pinion depth checker kits proform http amzn to 2a. Then loctite the pinion nut and tighten to 15 inch pounds rotating torque with used bearings or 25 inch pounds with new bearings. Dana 44 and 60 rear axle housings establish pinion depth by placing a shim underneath the large inner pinion bearing race. Ring and pinion gears are designed to be set up and run with exact tolerances.

Ring gear and pinion tooth pattern interpretation. This often requires driving in and removing the race more than once. Torque specs for the dana 60 are 120 ft lbs. Pinion depth the distance from the face of the pinion gear to the centerline of the ring gear.

Eaton performance ring pinion installation instructions. Hope you dig it. You must use red loctite or equivalent thread locker on the threads of these bolts.