I sanded each board one by one top ends and knocked the sharp edges off the corners for a worn farmhouse feel.
Cut your own wood flooring.
In a past life i had thought of the idea of buying solid oak plywood cutting it into strips and using it as inexpensive solid oak flooring and i was told that i was an idiot and carpet was chosen instead a far more expensive option when i had already exhausted my budget.
Now cut the new boards to width by running the tongue side against the fence.
You can either pile those pieces off to the side and return them to the mill later to cut the bark off or deal with the bark as part of the milling process.
I left the bark on.
Run all of the flooring through the machine on one of the long sides and one of the ends.
That gives you a guide of sorts.
One of the most popular uses for cutting wood floor planks with this saw is cutting the planks lengthwise also known as a rip cut.
Start by cutting a line all the way down where you want your cut to go.
Often when you cut like this the saw will cut out stringy wood.
Cut it straight through the center to make it manageable for your band saw.
Measure the face width of the existing flooring add the width of its tongue then set the table saw s fence that same distance away from the blade.
Make sure to always cut the wall end of the wood so that you do not cut off the groove that fits to the tongue.
That piece is a keeper.
Put the first board of the new row in place.
Don t try and cut from the top down straight through.
How to lay down your own inexpensive wood floor and make it look gorgeous.
The second cut will produce a piece that has two good faces but bark on two edges.
Adjust the fence and cutter height using a scrap piece of material adjust the cutter height and fence position until you have it set up correctly to run your flooring.
Scc cut all the 8 ft planks into 4 ft pieces then cut about 6 of those in half again to 2 ft sections.
If that happens that would result in a pretty big gap.
We ll cut it off when we turn the planks into flooring.
The saw will wander all over.
A circular saw is sort of like a table saw just with the portability of a reciprocating saw.
Planks can be cut with a hand saw circular saw or flooring cutter and most laminate flooring comes in planks that simply snap together with a tongue and groove system making it quick and relatively trouble free.
This removes the groove which you ll re create in the next step.
Cut it if necessary so the end is offset from the end of the board in the previous row by a minimum of 6 inches.
Set up the shaper or router table with a tongue and groove cutter.
Make sure when you make the mark to cut off the wall side not the room side.
Find a piece and lay it alongside the hole and flip it over.
Put the end against a 3 4 inch spacer and seat the edge snugly against its neighbor.
This makes it great for basic cuts or for a more skilled installer good for basic cuts for wood flooring as well.
